Buenas. No he encontrado en el foro a nadie que mencione esta placa.
Quiero usarla en modo monitor y según
https://wireless.wiki.kernel.org/en/users/drivers/iwlwifi se puede.
He descargado el supuesto driver pero no supe cómo instalarlo.
Cuando ejecuto
lspci, ya sea antes o después de mi intento de instalación, esto es lo que detecta
00:00.0 Host bridge: Intel Corporation Device 9b61 (rev 0c)
00:02.0 VGA compatible controller: Intel Corporation Device 9b41 (rev 02)
00:12.0 Signal processing controller: Intel Corporation Device 02f9
00:14.0 USB controller: Intel Corporation Device 02ed
00:14.2 RAM memory: Intel Corporation Device 02ef
00:14.3 Network controller: Intel Corporation Device 02f0
00:15.0 Serial bus controller [0c80]: Intel Corporation Device 02e8
00:16.0 Communication controller: Intel Corporation Device 02e0
00:17.0 RAID bus controller: Intel Corporation 82801 Mobile SATA Controller [RAID mode]
00:1c.0 PCI bridge: Intel Corporation Device 02b8 (rev f0)
00:1c.4 PCI bridge: Intel Corporation Device 02bc (rev f0)
00:1d.0 PCI bridge: Intel Corporation Device 02b0 (rev f0)
00:1f.0 ISA bridge: Intel Corporation Device 0284
00:1f.3 Audio device: Intel Corporation Device 02c8
00:1f.4 SMBus: Intel Corporation Device 02a3
00:1f.5 Serial bus controller [0c80]: Intel Corporation Device 02a4
02:00.0 3D controller: NVIDIA Corporation Device 1d13 (rev a1)
03:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller (rev 15)
Al ejecutar
ifconfig nunca me detecta ni wlan0 ni wifi0
eth0: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500
ether b4:a9:fc:6b:6a:b0 txqueuelen 1000 (Ethernet)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
eth1: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet 172.20.10.4 netmask 255.255.255.240 broadcast 172.20.10.15
inet6 fe80::b3:62ff:fe81:80d0 prefixlen 64 scopeid 0x20<link>
ether 02:b3:62:81:80:d0 txqueuelen 1000 (Ethernet)
RX packets 372910 bytes 515747134 (491.8 MiB)
RX errors 0 dropped 1 overruns 0 frame 0
TX packets 196188 bytes 14559930 (13.8 MiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536
inet 127.0.0.1 netmask 255.0.0.0
inet6 ::1 prefixlen 128 scopeid 0x10<host>
loop txqueuelen 1000 (Local Loopback)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
Quizá es más fácil y yo soy puro ignorante, pero así estoy.
Ante todo, muchas gracias.