Tengo un router zyxel VDSL P8701T con acceso al puerto serie,basado en Broadcom BCM63xx
picocom -b115200 /dev/ttyUSB0
CFE version 1.0.38-112.37 for BCM963268 (32bit,SP,BE)
Build Date: 12/20/2012 (curtis@SW3-202)
Copyright (C) 2000-2011 Broadcom Corporation.
NAND flash device: name Toshiba TC58NVG0S3ETA00, id 0x98d1 block 128KB size 131072KB
Chip ID: BCM63168D0, MIPS: 400MHz, DDR: 400MHz, Bus: 200MHz
Main Thread: TP0
Memory Test Passed
Total Memory: 67108864 bytes (64MB)
Boot Address: 0xb8000000
Board IP address : 192.168.1.1:ffffff00
Host IP address : 192.168.1.100
Gateway IP address :
Run from flash/host (f/h) : f
Default host run file name : vmlinux
Default host flash file name : bcm963xx_fs_kernel
Boot delay (0-9 seconds) : 1
Boot image (0=latest, 1=previous) : 0
Board Id (0-9) : 963168VX
Number of MAC Addresses (1-32) : 8
Base MAC Address : a0:e4:cb:67:7e:d0
PSI Size (1-128) KBytes : 128
Enable Backup PSI [0|1] : 1
System Log Size (0-256) KBytes : 0
Main Thread Number [0|1] : 0
Pero al intentar compilar una imagen de prueba:
Target: BCM63xx
Subtarget:smp
No veo nada parecido a 963168VX
